Tagged: axis force
August 17, 2019 at 9:16 am #109923
Hi, I printed the J-25 pieces, the bearings are: https://www.amazon.com/gp/product/B0045F7FJ0/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
it all mounted but I feel the strength to move the axis are not so loose, I need a little force to make it move. know if
How can I calibrate the rollers to make it more loose?
please let me know if other information is needed.
Cheers.August 17, 2019 at 9:32 am #109924August 17, 2019 at 11:27 am #109936TurbinbjornParticipantAugust 17, 2019 at 2:11 pm #109952August 17, 2019 at 3:48 pm #109962
Okay, if it’s hard to move them, then make sure any bolt holding a bearing with plastic on both sides is loose. Basically the nut is just there to keep the bolt from falling out. If it’s still tight, use it for a while, the plastic will loosen a bit over time.
Example, see that long bolt in your picture on the left side? That’s what I’m talking about by plastic on both sides of the bearing. Loosen any of those bolts so it’s not squeezing the plastic.
August 18, 2019 at 1:34 pm #110055
- This reply was modified 3 months ago by Barry.
Thanks Barry, I will lose all of them, but this one in the left is too lose 🙂
Cheers.August 31, 2019 at 4:59 am #111509
Hi Barry, if I lose the screws, all gantry gets loose, seems that it make the piece tight to the tubes.August 31, 2019 at 6:07 am #111515
- You must be logged in to reply to this topic.