MPCNC from NC

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 2 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #49580

    Daniel Dunn
    Participant

    It’s been a long journey but it’s finally printing! Next step is to do better cable management and build a nice little house for all the electronics. Then I’ll setup a CNCjs webserver on a RaspberryPi and document how that all happened since I owe this community after all the wonderful advice and guides that made this possible and helped me learn a ton about so many things I knew nothing about.

     

    1 user thanked author for this post.
    #49582

    Ryan
    Keymaster

    Quick cut off the ends of the wire sleeve and hit them with a lighter, they will keep unraveling otherwise.

    That is a nice looking build and a very robust size. You should have an easy time learning the CAM software like that. High Five!

    1 user thanked author for this post.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.