MPCNC dual xxyy endstops + cnc and 3Dprinter

New Home Forum Mostly Printed CNC – MPCNC Hardware Development – MPCNC MPCNC dual xxyy endstops + cnc and 3Dprinter

This topic contains 8 replies, has 5 voices, and was last updated by  Ryan 4 weeks, 1 day ago.

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #69662

    Allan
    Participant

    MPCNC dual xxyy endstops + cnc and 3Dprinter
    It is possible ?

    #69663

    Jeffeb3
    Participant

    You’ll need a board capable of driving six motors if you want to 3D print. That’s theain challenge. But it is possible.

    #69704

    Guffy
    Participant

    you may extend ramps with something like that https://aliexpress.com/item/42-DRV8825-A4988-3D/32851803627.html

    #69712

    Ryan
    Keymaster

    That is a nice little break out board. It Should make adding an extra stepper much easier. Don’t forget all the firmware updates as well.

    #69728

    Bill
    Participant

    Rumba also has six onboard…

    #69737

    Allan
    Participant

    MPCNC firmware support Rumba board ?

    #69738

    Allan
    Participant

    I have a MKS gen 1.4 board

    #69781

    Allan
    Participant

    That is a nice little break out board. It Should make adding an extra stepper much easier. Don’t forget all the firmware updates as well.

    what firmware

    #69797

    Ryan
    Keymaster

    If you add that break out board or another driver there will pretty extensive firmware changes needed.

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.