MPCNC build, South Dakota, USA

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC MPCNC build, South Dakota, USA

This topic contains 2 replies, has 3 voices, and was last updated by  Ryan 2 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #95003

    Sam Cotter
    Participant

    Working on putting the finishing touches on an MPCNC build! I continue to be amazed by Ryan’s design of this machine.

    Current challenge: getting the gantry square.

    24″x36″ cutting area, 5″ z-axis. 2×4 wood table, Ramps 1.4, just got the DW660 to try out next.

    I didn’t do dual end stops, but I’m now seriously considering it (mostly to solve squareness issues).

    Next up: building an enclosure for dust control.

    Thanks to everyone on the forums for the good discussions. It has been a great resource.

    #95111

    Dakota Jim
    Participant

    Looking good.

    Where in SD? I’m in RC.

    #95255

    Ryan
    Keymaster

    That’s a big one, can’t wait to see what you make!

     

    Welcome.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.