Minitronics V2.0 for lowrider cnc V2

New Home Forum LowRider Advice – LowRider Minitronics V2.0 for lowrider cnc V2

This topic contains 5 replies, has 5 voices, and was last updated by  Aaron 1 month ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #106735

    jackomalo
    Participant
    #106801

    Bill
    Participant

    You’d likely be on your own for that one, I didn’t see any indication that Marlin or Grbl is setup for it.

    #106811

    Erwin Vigilia
    Participant

    Datasheet says it uses the same ARM Cortex micro the Arduino Zero (SAMD21J18). You’d have to modify a Marlin build for that processor and reconcile the pin mappings (page 10 of the datasheet) against the pins.h file in that build.

    • This reply was modified 1 month ago by  Erwin Vigilia. Reason: more info
    #106815

    Jeffeb3
    Participant

    Datasheet says it uses the same ARM Cortex micro the Arduino Zero (SAMD21J18). You’d have to modify a Marlin build for that processor and reconcile the pin mappings (page 10 of the datasheet) against the pins.h file in that build.

    IDL what kind of motor drivers or other peripherals it has though. If it has digipots, for example, those will need to be configured too.

    #106816

    Jeffeb3
    Participant

    And if if doesn’t have the arduino bootloader, you’ve got to install that or program it another way.

    #106824

    Aaron
    Participant

    there’s a firmware file at the bottom of the page, inside it has a .ino and other files that look like a marlin build. you’ll have to make sure the steps are correct and it will probably work.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.