Mini Rambo firmware install – first layer error

New Home Forum LowRider Troubleshooting – LowRider Mini Rambo firmware install – first layer error

This topic contains 1 reply, has 1 voice, and was last updated by  Lachy 1 month, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #105994

    Lachy
    Participant

    i have the marlin firmware install in my new mini rambo, motors move, extruder and bed heat.

    i started a print and it immediately starts making a squiggle line toward the opposite corner from the home position and crashes into the end of the x and y axis

    any ideas?

     

    #106002

    Lachy
    Participant

    i believe the problem was cause by and incorrect setting in marlin to do with the mechanical endstop inversion.

    it could also have been the firmware endstops causing the issue

     

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.