- July 13, 2017 at 11:16 am #38198
Will update pics with progress 🙂
Attachments:July 13, 2017 at 12:38 pm #38212
Looks a lot like the first pictures from @Barry.July 18, 2017 at 12:35 am #38670
Haha, his pictures look very alike!
Even the writing on the right side of the table !
Getting closer to finish with my assembly !
Attachments:August 9, 2017 at 7:35 am #40469
There it is !
(Feet of table are just temporarily)
Attachments:August 9, 2017 at 7:51 am #40477
I thought the feet on my table were temporary as well, still there.August 9, 2017 at 8:04 am #40485
Boy, that looks very flat. Good job. I look forward to seeing it making some things.
Also, I’m still on my temporary legs as well (which were actually from my MPCNC). I’m about to add wheels to them though. 🙂August 10, 2017 at 11:54 am #40612
Indeed very flat 🙂
Built after the torsion table design (i think it was mentioned here a few times)
Pictures of :
-Little thingie for the girlfriend (second cut with the lowrider)
Attachments:August 10, 2017 at 3:29 pm #40635
Very nice. I don’t want to drive you crazy, but I wonder how this test would do on your low rider (I haven’t seen any other results):
I think you could do something similar with a touchplate, but I haven’t looked into how to do that yet.August 11, 2017 at 2:19 am #40738
Wouldn´t it be easier to simply mount a distance sensor to the 611 plate and let it measure a matrix?
Like my printer does autoleveling?August 11, 2017 at 4:26 am #40742
The most common way distance is sensed is just with a touch plate. You can use a spatula or something, attach a wire to it, attach another wire to your bit, and wire them as endstops. Then you just subtract the thickness of the spatula. EstlCAM had a video where they used foil tape.
There is also Software for building a mesh. The EstlCAM video carved a 2d design on the back of a mouse.September 19, 2017 at 11:02 am #44223
Realized the table isn´t as flat as i thaught!
Got like 1,5mm difference from start to end of the table!
But i´m still very happy with the machine!
Here´s a picture where i engraved the workingspace with a V-Bit and tested some letters 🙂
Attachments:September 19, 2017 at 11:22 am #44229
That’s pretty good. Did you see my Z test here?
You must be logged in to reply to this topic.