Maximum Size

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #32179



    I think this may have been asked before. I am thinking of building a MPCNC slightly bigger than 4′ x 4′ The reason is because I wish to load a full piece of plywood into the machine.

    But I do not want to sacrafice on accuracy too much. Will a 4′ x 4′ machine be rigid/accurate? Or am I better off building two machines (aka low rider). I see there are support mounts for the MPCNC.



    Go with the LowRider, that is what is was built for.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.