LR2 – Table Height

New Home Forum LowRider Advice – LowRider LR2 – Table Height

This topic contains 5 replies, has 5 voices, and was last updated by  Barry 3 weeks, 6 days ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #93768

    Matt
    Participant

    Hi

    Does the 4″ restriction height ‘restriction’ still apply the the LR2 design. I’m guessing it applied to the old version because the gantry had wheels underneath?

    Thanks

    #93770

    Jeffeb3
    Participant

    There are still parts that hang underneath so it’s stil a limit.

    1 user thanked author for this post.
    #93853

    Matt
    Participant

    thanks Bud

    #94142

    Dan Roesch
    Participant

    What is the x axis thickness of the table that needs to be <4″ for clearance? I want to extend an existing bed that is already over 4″ with a 3″inch skirt if that makes sense.

    Also does anybody do a leveling pass of the entire waste-board top once everything is assembled to get it completely dialed in?

    Thanks,

    Dan!

    #94289

    Ryan
    Keymaster

    Shoot, Mine is still in a ice chest from the move. Quick guess is 2-3″

    #94436

    Barry
    Participant

    I did a finishing pass on my table.  Need to redo it though.  For some reason my 200 year old barn floor moved over the winter causing the table to not be flat.  🙄 😆

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.