LR2 Recommended Print Settings

New Home Forum LowRider Advice – LowRider LR2 Recommended Print Settings

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #69193

    Dave C.
    Participant

    I have read the post about the recommended infill percentage, but should some LowRider V2 parts have higher infill over others?

    #69211

    Ryan
    Keymaster

    Not nearly as important as the MPCNC parts were. I am starting to design so it doesn’t matter. Meaning lots of exterior walls and surfaces instead.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.