Lowrider vs MPCNC for small build

New Home Forum LowRider Advice – LowRider Lowrider vs MPCNC for small build

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 11 months, 4 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #28301


    If built at a smaller scale, say 30’x30′, how would the lowrider compare to a MPCNC of the same size ?
    It seems more rigid, since one axis is fully supported by the table, so would it be more precise ?

    I’ve been eyeballing an mpcnc build, bow now I’m hesitating between the two 😛

    @vicious1: thank you for all the hard work you’ve put into this project! 🙂



    You’re welcome and thank you for the kind words.

    Honestly I, really have no idea. It will be a larger footprint but I would imagine it would be more rigid as long as you keep a short z axis. Before you ask I am not sure how tall it can get before it is unusable. There are only 2 fully operational ones in existence right now and I don’t think either of us has founds its limits in any way yet.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.