Low Rider 2 Rugged 6×12 Build

New Home Forum LowRider Your Builds – LowRider Low Rider 2 Rugged 6×12 Build

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by  Marvin Lange 9 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #85077

    Marvin Lange
    Participant

    Going with rugged design aluminum 611 plat milled Plastic  XY Plates

    https://1drv.ms/a/s!AuFirwug-g8_j_QNXj-DKwLfvfX11A

     

     

     

     

     

    2 users thanked author for this post.
    #85089

    Jeffeb3
    Participant

    Aluminum 611 plate with a laser! Cool. What kind of aluminum is that?

    #85207

    Marvin Lange
    Participant

    Its from my old MPCNC hot Bed not sure what type but its very Rigid no flex most of the videos I see them their 611 plate flex when they enter Material i am trying to eliminate that. I have the File from ESTLCAM if you want it the holes on front and back are for 12mm Line Lasers so I can make X at Router Center and X at Laser Center will put on switch for alignment.

    I wanted to Use that  Trochaidal Milling Bunt my Arduino would just lock up as soon as I tried to run Code.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.