Looking for Burly parts, just the gantry / Z Axis

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Looking for Burly parts, just the gantry / Z Axis

This topic contains 3 replies, has 2 voices, and was last updated by  Ryan 3 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #115192

    JonJ
    Participant

    I have my MPCNC all set up and working. I would like to upgrade to the Burly parts, but just the Gantry / Z Axis.

    Are just those pieces available?

    Thanks

    Jon

    #115200

    Ryan
    Keymaster

    Not sure what you are asking. The parts are on Thingiverse but may or may not work with what you have. The entire center typically needs to be replaced at the same time.

    • This reply was modified 3 weeks, 2 days ago by  Ryan.
    #115285

    JonJ
    Participant

    Ryan,

    I apologize for the confusion.

    I am looking for the entire center but looking from getting it from you rather than printing.

    in the V1 Engineering Shop, i see available the burly printed parts. but for an entire MPCNC, not just the entire center.

    Thanks

    Jon

    #115449

    Ryan
    Keymaster

    It depends on what corner versions you have, the spacing changed a bit at one point so if you are not on the new corners and new stronger feet.. If you need to get the corners you might as well just get it all.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.