Linear rail extruder mount

New Home Forum Things You Have Made Linear rail extruder mount

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #95666
    Greg
    Participant

    This was done on a LowRider V2 and cut in 4 minutes from 2mm aluminum using gcode exported from fusion.

    The accuracy seems really good.. there was less than .2 mm tolerance on the holes and all the bolts fit.

    Lessons learned after a few broken bits: For aluminum plate get a single flute upcut mill but one with a short flute length (not much taller than the plate).  Get your machine very accurate otherwise you will have problems when your passes don’t line up.

     

    2 users thanked author for this post.
    #95739
    Ryan
    Keymaster

    Nice!

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.