March 26, 2017 at 6:56 pm #30266
Has anyone tried printing on polycarbonate (Lexan)? I have been experimenting with different surfaces trying to find one build plate that works for different filaments. I think I found it!
It’s suppose to work great for ABS, but I have not tested this yet. It works great for PLA and SemiFlex. For PLA, I heat the bed to 55 degrees C. The sheet can be removed and flexed to pop the part off. For SemiFlex I set the bed temperature to 90 degrees C. SemiFlex won’t pop off, but it can be pealed off using a razor blade.
I have been using this for a few weeks now. Between prints I’ve been wiping it down with alcohol. Has anyone else tried this?
DaveMarch 27, 2017 at 12:08 pm #30315
I used a sheet for a while it did work pretty good but once I tried PEI I won’t be changing anytime soon.March 28, 2017 at 4:12 pm #30387
I’m having trouble with PEI. My parts often don’t stick well enough, I had a 11 hour print a couple of days ago get to within an inch of the top when the bottom let loose (not surprisingly, I wasn’t watching and ended up with a part that was short with an afro).March 28, 2017 at 4:14 pm #30388
kick up the bed temp 3-5 degrees. 60 works for me with most everything except the toolmount (tall and thin), for that I use 64. I also give it an alcohol wipe before each print.March 28, 2017 at 9:43 pm #30433
I did kick the bed up, but not quite that high. Tomorrow I’m making ribs for dinner (and roasting coffee for later in the week) and will have loads of time to watch a big print. I’ll start with 60 and go a bit higher if it’s looking weak.
You must be logged in to reply to this topic.