- September 13, 2017 at 2:46 am #43736
So I’ve got my ER11 collets finally so tomorrow I will try (for the first time) at cutting something. I’m going to put a spoil board in place and I will need to run a flat bit over it to cut it so it’s level.
How do I do this on estlcam? The bit would obviously need to travel the whole X or Y, move over abit, then go back and so on until the whole board is done.
Is there a Gcode that someone can share or a tutorial how to draw that on a design software?
And any other tips I might need for a first timer
ThanksSeptember 13, 2017 at 3:56 am #43739
I created a box in 123design the size of my cutting surface, exported to dxf. Opened that in estlcam and put the zero at the center, then did a hole with a pocket and peel cut it at .5mm depth of cut. You could use anything to make the dxf, but any program that works like adobe illustrator(inkscape) just confuses the crap out of me.September 13, 2017 at 4:09 am #43740
Thanks Barry. I get the box part and .5mm depth of cut, but how will this do the whole board? Do I have to make a box inside a box inside another box and so on? until I get to the centre? Sorry but very new to all this?September 13, 2017 at 4:25 am #43741
No, you just make one big box (I would use libreCAD, but not trying to start a flame war). You then do a pocket operation in EstlCAM, which will compute the coordinates to cut out the whole thing.
You’d just click hole, then the box, then the pocket button.
Just play with it a little, try the different pocket strategies and look at the preview.September 13, 2017 at 4:28 am #43742
If you make a pocket in Estlcam like Barry mentions it will clear everything inside the pocket. That’s why its called pocket. Play with the Estlcam program a bit and it will show you the toolpaths in a preview so you can see how it will cut. I will be doing this myself soon. Good luck!September 13, 2017 at 4:34 am #43743
And to add yet another option…
Fusion 360’s CAM software has a function for ‘facing’ a part. I created a box the size of my spoilboard -.5mm, then told the software to face it.September 13, 2017 at 11:25 am #43769
Got it. Thanks heaps guys for your help.September 13, 2017 at 11:54 am #43773
Jeffeb3ParticipantFusion 360’s CAM software has a function for ‘facing’ a part
Alright, that’s it! I declare flame war!September 14, 2017 at 4:04 am #43826
My spoil board is the same size as my cutting area, so there were a couple “walls” on the edges, but they cleaned up with a chisel pretty easily.
You must be logged in to reply to this topic.