Leveling the mpcnc

This topic contains 2 replies, has 2 voices, and was last updated by  Ryan 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #103507

    Ryan
    Participant

    how do you guys go about leveling the MPCNC? I am 3d printing shims out of PLA and using putting them in the sockets of where the conduit sits.

    #103508

    Barry
    Participant

    I use a block of wood.  Cut it the height you want under the lower rails.  Then start at one corner and stick it under the rail.  Tighten down the screws, and move to the next corner.

    #103509

    Ryan
    Participant

    ok then

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.