Leo69 Laser – having some issues getting to work

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Leo69 Laser – having some issues getting to work

Tagged: , ,

This topic contains 2 replies, has 2 voices, and was last updated by  nicon 2 years, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #26405


    hello –

    I have the leo69 laser finally created after waiting almost three months for the dang driver. However having some issues and hope someone with a little more experience can chime in on things to try.

    1) when i set the voltage – no issues
    2) when i try to set the current (i am using the testing method with resister) i have issues that its SOOOO touchy that often it drops from 400mv to 3v with such a small turn .. i have been able to get it to about 1.3v but again its like you breath on this and it may move. the driver i have is (http://www.ebay.com/itm/321786637275?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT)

    but i would guess at 1.2-1.4v i would still be able to get a visible light from it in testing. (again, the output on my testing seems that i should have voltage to the laser)

    My big issue of course is that i cant see any visible light from the laser — and i have about 1.2-1.4v when i test the resistance with the method of testing the resistance.

    my asks:
    1) any way to test my laser to see if it works w/o the driver (this is the laser i have — http://www.ebay.com/itm/180948107479?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT)

    2) have you seen this calibration so touchy? // if it should not be, can you recommend a place to order that we know is good?



    Are you adjusting the right component. I had to turn mine several times before I would get significant voltage changes.



    correct- what you have circled is what i am adjusting to “try” to align with the 1.7v in the test … the best i could get was 1.4

    I adjusted the voltage first with the other pot

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.