Length of screw.

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #106202

    Erik
    Participant

    I ordered a 300 mm screw and only made my z axis 12” long. So my screw is about an inch or so past the bottom of the z conduit. Should I cut it flush? Or make my z conduit longer or will it be ok?

    Attachments:
    #106205

    Ryan
    Keymaster

    The lead screw should be at least as long as the calculator specifies, but no longer than the bottom of the Z rails.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.