lead screw length?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC lead screw length?

This topic contains 2 replies, has 2 voices, and was last updated by  Ryan 2 years, 5 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #24348

    Ryan
    Participant

    should this equal the Z axis pipe lengths?
    Thank you.
    (getting close but long wait on shield via amazon)

    vicious1, as I put this project together I am very impressed with the design that went into it.
    Thanks for all the effort!

    (already scoping the basement for a location for a lowrider build)

    #24349

    David
    Participant

    You don’t want it to extend further than the pipes or your’re reducing your print/cut height. As someone who cut their screw after it was installed, take my advice and cut it *before* you get everything else set up.

    #24358

    Ryan
    Participant

    thank you!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.