issue with center assembly motor mount

New Home Forum LowRider Troubleshooting – LowRider issue with center assembly motor mount

This topic contains 4 replies, has 3 voices, and was last updated by  Kyle 3 weeks, 2 days ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #115510

    Kyle
    Participant

    I’m not sure if the 3d part i received is incorrect or if im doing something wrong but it appears that these screws should go into the hole of the mount and screw in deeper within the mount? picture attached is the issue im having where the screw is stuck at the top. I had purchased the parts from the v1 shop

    #115518

    Bas Goossen
    Participant

    The screw head should sink into the printed part. You should use the 3mm short screw. Can you drill it up? By how much is it smaller than the screw head?

    Is the hole clearly smaller on the other side?

    • This reply was modified 3 weeks, 2 days ago by  Bas Goossen.
    #115548

    Kyle
    Participant

    yeah i am using the 3mm screws that were provided in the kit. I’m sure if i drill out the hole to make it bigger that should work.

    #115559

    Ryan
    Keymaster

    I think the issue is called elephant foot. The first few layers were too squished and made the hole smaller right there. Just chamfer the holes a bit or scrape it out with a knife. The screws should fall in.

    #115564

    Kyle
    Participant

    i will have to try that when i get home. Thanks!

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.