How to set micro-stepping on my MPCNC

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC How to set micro-stepping on my MPCNC

This topic contains 7 replies, has 3 voices, and was last updated by  AL 2 years, 7 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #25143

    AL
    Participant

    Are there any instructions how to set the micro-stepping on MPCNC?

    #25155

    Martin DB
    Participant

    Are you using the recomended RAMP 1.4? Just play with the 3 jumpers under the steeper driver.

    #25165

    AL
    Participant

    Yes, I purchased all from Vicious1, My question is in software level,
    I move X-axis by50mm on the LCD screen and the movement is actually 63mm. How do I set the steps to be accurate?

    #25168

    Martin DB
    Participant

    Have you changed something in marlin config? If you bought all form Ryan, this should work ok.

    #25172

    AL
    Participant

    No, just installed as is!

    #25176

    Derek P
    Participant

    This sounds like the pulleys are not defined properly. Stepping will double or halve the distance.

    #25179

    Martin DB
    Participant

    May be you have changed steps/mm from lcd? Try Restore Failsafe options on the LCD menu to load “factory” defaults.

    #25182

    AL
    Participant

    But even running in manual mode Repetier behaves the same way

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.