- April 28, 2017 at 11:04 am #32347
My current set up uses the 25mm kit with a DeWalt 660 with a 24″ x 24″ work space. I primarily use it for milling wood (pine) and foam. I read the install instructions and reviewed comments in the forum in reference to tightening the screws and bolts that contact the 3D printed parts, as I have never worked with 3D printed parts before.
After about two months of on / off use both tool mounts snapped and I was able to purchase replacements. Today both Z brackets snapped dropping the Z axis right into the project. I was wondering if there was anything I could do to prevent this in the future.
Attachments:April 28, 2017 at 1:11 pm #32354
Either those parts were printed poorly or you over tightened them. It is plastic and it does grip metal well, you really do not need much tension I promise.April 29, 2017 at 4:08 am #32372
Ryan, is it possible to purchase these parts? I purchased the entire kit and additional mounting brackets from this site, but there is no option to buy other pieces that I can see.April 29, 2017 at 8:21 am #32376
If you want to either PM me or use the contact for to give the email you used I can send you an invoice.
You must be logged in to reply to this topic.