how level is level enough?

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP how level is level enough?

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 12 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #30069


    I’m branching out into the printing realm now and need to know if I’m being too anal about getting my build plate level. I come from an inspection background so we can split hairs if need be. is .003 over a 5 inch span too uneven? Figuring one millimeter is .039 inches I would think I could keep it in the +/- .005 range. Will that cause me any problems? How many people use MOSFETs with their hot beds?



    Yes, that is a great number.

    I do mine by eye so I am sure I am way worse off that that.

    External mosfet, should not be needed unless you are running something larger than usual, or tend to always run at 100C+. I have not needed to take a bed above 65C, but I also use PET instead of ABS.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Pin It on Pinterest