Hose coiling on full size table

New Home Forum LowRider Troubleshooting – LowRider Hose coiling on full size table

This topic contains 6 replies, has 3 voices, and was last updated by  Greg 2 months, 1 week ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #103232

    Greg
    Participant

    Setting up my full sheet table and I can’t get the hose to coil along the aluminum angle no matter what I do. I zip tied it in the middle but it still falls off the track on the far end.

    Any suggestions?

    #103234

    Jeffeb3
    Participant

    Are you talking about the vacuum hose? I have just taken for granted that it works. I’m not sure how.

    #103238

    Greg
    Participant

    Yeah.. mine is not cooperating.  I managed to get it working by zip tying a couple giant 4 foot zip ties from the dollar store to the hose to make it less flexible.

     

    #103241

    Ryan
    Keymaster

    I had to get just the right twist and zipping it to the rigid part of the cord. It almost comes off on both ends but it is perfect in the middle.

    The other solution would be to get wider angled aluminum.

    1 user thanked author for this post.
    #103242

    Greg
    Participant

    Ryan how wide was your aluminum?  Do you have pics of your hose setup?  I never even though of twisting the hose that gives me some ideas.

     

     

    #103244

    Ryan
    Keymaster

    1.5″ pics and a video on thingiverse.

    #103245

    Greg
    Participant

    Oh man I had my hose alllllll wrong.  Thanks.

     

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.