Has anyone recreated the 25.4mm Burly assembly file?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Has anyone recreated the 25.4mm Burly assembly file?

This topic contains 4 replies, has 3 voices, and was last updated by  Benjammann 2 months, 1 week ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #82387

    Benjammann
    Participant

    I’m about to have to Frankenstien this thing together. Can anyone save me?

    #83480

    Bahri16
    Participant

    Hi Ben,

    I am starting my journey with printing my part, I live on the east cost of the US and my first issue is to get the 25,4 mm OD conduit.

    from where did you get the conduit if you are from the US?

    Thx

    #83484

    Ryan
    Keymaster

    I live on the east cost of the US and my first issue is to get the 25,4 mm OD conduit.

    That does not exist here, have a look at the parts page, size page, or specs page for details.

    #83538

    Bahri16
    Participant

    Thank you Ryan,

    I read it so many time, I think I was so excited to start the the project, I ignored it, until this morning when I went to home depot and measure the conduit.

    I am glad ask the question on the forum, I already waste 10 hours printing the 25.4mm.

    Better than finding the issue later, Ok Let start printing the 23.5mm one

    again Thank you.

     

    #83543

    Benjammann
    Participant

    Hi Ben,

    from where did you get the conduit if you are from the US?

    I ordered it online from McMaster here

     

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.