Grinding when X axis homes

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Grinding when X axis homes

This topic contains 1 reply, has 2 voices, and was last updated by  Jeffeb3 3 weeks, 3 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #118673

    Benjammann
    Participant

    Just fired up the MPCNC after a few months break and I’m getting grinding when the X axis homes. It goes up to the switches and tries to keep going for a few seconds, then finally backs off and retries it, then it is successful.

    Am I homing to fast? Bad switches or wiring? Belts too tight? Going to test some of these things tonight but I thought I’d see if anyone has an idea of what it could be.

    #118679

    Jeffeb3
    Participant

    Probably switches or wiring. Check their functionality with M119 first.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.