Grbl on RAMBo w/ Dual Endstops!

New Home Forum Software / Firmware Development Grbl on RAMBo w/ Dual Endstops!

This topic contains 32 replies, has 9 voices, and was last updated by  Paul 1 week, 2 days ago.

Viewing 3 posts - 31 through 33 (of 33 total)
  • Author
    Posts
  • #120643

    Paul
    Participant

    Ok, so all I changed was $1=255 and still nothing fom steppers. My switches have no affect on the Pn:XYXH readout when I open them from NC.

    It’s seems like the pin assignment for the steppers is off??

    Thanks

    sorry about the blank posts, Didn’t realize the posts go on to a second page, didn’t think my post was going through.

    • This reply was modified 1 week, 2 days ago by  Paul.
    #120645

    Paul
    Participant

     

     

    • This reply was modified 1 week, 2 days ago by  Paul.
    #120646

    Paul
    Participant

    Still nothing from the steppers. I’ve only changed $1=255. When I ‘?’ the output Pn: XYXH does not change when I hold any of my normally closed limit switches

Viewing 3 posts - 31 through 33 (of 33 total)

You must be logged in to reply to this topic.