Fusion 360/Inventor HSM finishing pass

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Fusion 360/Inventor HSM finishing pass

This topic contains 0 replies, has 1 voice, and was last updated by  David Walling 10 months, 3 weeks ago.

Viewing 1 post (of 1 total)
  • Author
  • #32549

    David Walling

    I wasn’t sure where to put this, so I’ll stick it here.

    I’m milling a piece of MDF. My design is more intricate than what a 1/8″ bit can cut, so my plan is to hog out most of it with the 1/8″ end mill and then come back with a 1/16″ for the cleanup.

    The adaptive cut with the 1/8″ goes fine, but when I go to do another adaptive with the 1/16″ mill, the software wants to recut all the stuff that was already hogged out. I’ll need the 1/16″ to make multiple depth cuts in part of it, so I can’t just tell the software to do a full depth cut.

    Am I missing a button that tells the second process to only cut what’s left?

    Also, where do I tell the software to go back to the zero point after finishing the first process so I can change bits?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Pin It on Pinterest