Fusion 360 relief cut

This topic contains 1 reply, has 2 voices, and was last updated by  Barry 3 weeks, 6 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #114981

    Will smith
    Participant

    Hi I tried a relief cut on fusion 360 then saved it to the address card and ran it  I think this line problem is my step over was set to 2 mm and my bit is a 1/8 ballnose thats 2mm wide at the tip   Can some one verify its the step over that cause the lines.  Because other that that it came out pretty well

    #115006

    Barry
    Participant

    Ball endmills need a fractional stepover. Like 50% or something close to that.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.