False bottom for 3D printer enclosure

New Home Forum Things You Have Made False bottom for 3D printer enclosure

This topic contains 0 replies, has 1 voice, and was last updated by  Barry 2 years, 8 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #25826

    Barry
    Participant

    Been on my to-do list for a while now. Client canceled appointment this morning, so I had time to tinker around. I have a fan blowing into the bottom of the enclosure for cooling air for the electronics. This keeps the warm printing area separated.
    https://goo.gl/photos/gFL5ouNLGBJDHswU6
    https://goo.gl/photos/2GdVbgtMiXUsPJ876

    Router went nuts on the back side of the cut. Think it sagged and caught on the plywood. Not a huge deal, it’s close enough. I don’t want it touching, keeps the vibrations down. The printer is sitting on a cut up neoprene mouse pad as well as having stepper dampers installed. You can’t really hear it printing outside my room. Before the plexy and dampers were installed, you could hear it all over the house.
    https://goo.gl/photos/eLScS7TxjvJmps4q9

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.