extruder mount

This topic contains 6 replies, has 3 voices, and was last updated by  omarb 7 months ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #53238

    omarb
    Participant

    Hello everyone, i was looking at the MP3DP v2 printer and there’s something i don’t understand how’s the mk8 extruder is mounted to the printer i’ve tried looking at the pictures but it’s not clear

    #53239

    Jeffeb3
    Participant

    The extruder strap hooks around the motor.

    1 user thanked author for this post.
    #53240

    omarb
    Participant

    I think i got it, after looking at the parts i think the extruder strap goes around the mk8 extruder and then get fixed to the the part named X.stl with two screws, is that how it works ?

    #53241

    Ryan
    Keymaster

    Yup

    1 user thanked author for this post.
    #53243

    omarb
    Participant

    thank you ,  i’ve decided to build the MP3DP before the Lowrider , wish me luck

    #53244

    Jeffeb3
    Participant

    Good luck! I had an MPCNC, then an MP3DP and then I built the low rider. I’ve been smiling the whole time (that’s at least what my avatar has been doing).

    #53249

    omarb
    Participant

    i hope i’ll be smiling too, thanks a lot Jeff

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.