ESTLCam Oddities?

This topic contains 1 reply, has 2 voices, and was last updated by  Melvin 1 month, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #98646

    Kelly D
    Participant

    Has anyone ever experienced ESTLCam running on forever when preparing gcode files (to the point where you force quit the software and try again)? Normally it starts churning on triangles (the is is for ST: conversion – free machining) in the log that presents when programming the gcode file. Today however it started listing Z depths and went on and on forever. I even opened old files which exported just fine and they started going to infinity on me. Is there a preference file I can trash to reset ESTLCam?

    #98805

    Melvin
    Participant

    It does take a long time on some of my more complex projects. I have to walk away and go sand something. It’s usually done when i come back.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.