estlcam depth tool finish

New Home Forum Software / Firmware Development estlcam depth tool finish

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 3 weeks, 5 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #103809

    giuliano
    Participant

    hi everybody, I use estlcam

    I would like to know if is possible to set a max depth for the finishing tool in 3d .

    i.e. I set a deph of 60 mm for the rough tool  and i would like to say to the finishing toll (2 mm and 20 mm lengh tool) to go depth not more of 20 mm. I see that is possible in 2d but I dont know how to do it in 3d.

    I have to mil  a piece that need to be finished only for the  first 6 mm.

    thanks a lot.

    G

    #103849

    Ryan
    Keymaster

    I am not super clear on what you are asking but I do not think that is possible. The STL settings are pretty automatic for “3D”.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.