Error: print halted

Tagged: 

This topic contains 5 replies, has 3 voices, and was last updated by  Manolo Suarez 1 week, 4 days ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #119737

    Manolo Suarez
    Participant

    Hello,  I was doing some tests for my work table size and Gantry extremes position and realize when I set the  command of: “G00 X470.0000 Y380.000 Z5.0000 F2100” that is the extremities of my worksite bed the Gantry is sent to the opposite side of Home, that is correct. So when I press HomeX button in Repetier host Mac, the gantry moves to half way of X and stops, I found the last line shows in red: “ERROR: Print halted. kill() called!”, and I have to disconnect and connect again to get the Gantry to move. Is there some related to the bed size or machine size? Do I have to set bed size in the firmware? I did not.

    I am using endstops, LCD, Repetier, on the Mac.

    1

    2

    3

     

    • This topic was modified 1 week, 4 days ago by  Manolo Suarez.
    • This topic was modified 1 week, 4 days ago by  Manolo Suarez. Reason: typo
    Attachments:
    #119755

    Jeffeb3
    Participant

    Yes, there is a BED_SIZE in Configuration.h and it’s set to 200mm. You’ll need to bump that up if you want to home from way over there.

    1 user thanked author for this post.
    #119756

    Manolo Suarez
    Participant

    Hi Jeffeb3, ok so I will try, it is in mm Am I wrong?

     

    #119757

    Barry
    Participant

    Yes. Or you could just hit home again.

    2 users thanked author for this post.
    #119758

    Manolo Suarez
    Participant

    Hi Barry, does not work since it is halted I have to disconnect Repetier and connect again to make it work. I think is more safe to fix it in the firmware, don’t you think?

    #119759

    Manolo Suarez
    Participant

    Hi Jeffb3, just change and it is working. 🙂

    Thanks

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.