ER11 collets on Katsu (Makita clone) trimmer?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC ER11 collets on Katsu (Makita clone) trimmer?

This topic contains 2 replies, has 2 voices, and was last updated by  Jethro 5 days, 8 hours ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #103171

    Jethro
    Participant

    I received my Katsu yesterday, and they’re just fit 8mm & 6mm bits. Had a look on Amazon, and not much available here in Europe, for sure not at a reasonable price.

    On Ali are adapters available https://bit.ly/2R9v54u , or better a ER11 collet set https://bit.ly/2wMLDpt , don’t like the idea using adapters.

    Apparently some on the forum are using the ER11 collets, can some(one) confirm that they fit or does it need further modifications?

    #103193

    Andy
    Participant

    You can buy a ER11A. It’s and extension rod with the er11 fitting to take the collets, the extension bar then fits in the makita Chuck. The bar probably needs cutting down as they seem to vary in length depending on where your getting them from.

    1 user thanked author for this post.
    #103225

    Jethro
    Participant

    Yep,seems to be right. I just opened the Katsu and it seems to be the only way.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.