End stop limit switch catching on belt.

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC End stop limit switch catching on belt.

This topic contains 2 replies, has 2 voices, and was last updated by  Ryan 2 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #100469

    Ryan
    Participant

    All of my other end stop switches are good and have clearance. But this does not and I cant seem to figure out why can anyone tell me? First picture shows the switch in question, other shows it just fine.

    #100472

    Ryan
    Keymaster

    The yellow part is upside down, Or you didn’t print the mirrored set.

    #100473

    Ryan
    Participant

    Ok thanks

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.