End of cut program cuts through work

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC End of cut program cuts through work

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 4 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #114874

    Sam
    Participant

    Sometime when I use kiri:moto once the job is finished it will for whatever reason on its way back to origin cut through the entire work piece. It only happens on occasion but it’s quite annoying to say the least. Would any gcode fluent tinkerers be able to look at the last lines of gcode to see if theres some command I can remove to prevent this?

    Attachments:
    1. clock-tabs.gcode
    #114994

    Ryan
    Keymaster

    Your post processor is not doing it’s job. None of your commands have an associated speed with them so if it is asking for something outrageous Marlin will just ignore it sometimes.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.