Emergency stop button

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Emergency stop button

This topic contains 1 reply, has 2 voices, and was last updated by  Martin DB 2 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #25061


    I purchased one of these emergency stop buttons from the shop here – but i’m not sure how it should be wired.

    Do I need to put it between the power supply and the ramps board? I’m using a 12V 6A power brick.


    Martin DB

    I’ve connected it between the main power and the power supply AND the spindle. So my stop button power off all the machine.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.