Drew my first square – diagonal off 2mm. Which endstop do I move?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Drew my first square – diagonal off 2mm. Which endstop do I move?

This topic contains 3 replies, has 2 voices, and was last updated by  Bill 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #119656

    BillM
    Participant

    Dual Enstops: I’m off by 2mm on one of the diagonals, which end stop do I move? See Picture

    Diagonal-Measurements

    #119692

    Bill
    Participant

    You want the top left to move slightly to the left in order to shorten the long diagonal and lengthen the short one. Make sure your MPCNC is square first though.

    #119695

    BillM
    Participant

    Hi, Bill, yes it is square already.  Thanks for your prompt reply!

    #119850

    Bill
    Participant

    You can tweak the software to ‘move’ the endstops in increments of less than 2mm as needed. I’m pretty sure Ryan has that explained in the dual end stop pages.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.