Control board

This topic contains 2 replies, has 2 voices, and was last updated by  Konstantin Borisov 3 years, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #14951

    Konstantin Borisov

    I’m trying to build my own MPCNC. I’ve printed parts and assembled the mechanics. Now I’m trying to choose electronics.
    And here I have a problem. In Internet RAMPS boards are used mostly to control 3D printers. But I want to use my MPCNC for paper cutting and later 3d milling.
    RAMPS is very interesting because there is a SD card reader for it so I hope I’ll be able to do cutting without computer.
    Is there any software for RAMPS board to generate g-codes for 3d-milling and 2d-cutting? What control board should I buy for that?



    Ramps does it all very well.

    Have a look at the home page for the estlcam posts. It can do everything you want.


    Konstantin Borisov

    Thank you very much!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.