"Connection Error"- Message when I first open Estlcam on mpcnc

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC "Connection Error"- Message when I first open Estlcam on mpcnc

This topic contains 3 replies, has 2 voices, and was last updated by  Ryan 3 months, 4 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #55650

    joe
    Participant

    I tested the x,y & z axis with pronterface thru Cura & everything worked fine. – I have just finished the setup for “The Crown” – But , when I hit connect on Estlcam I GET THIS MESSAGE –“Connection failed” -“The parameter is incorrect”- I just dont know where to look ?? thanks Joe

    #55651

    Ryan
    Keymaster

    Do not hit connect.

    Step 6

    EstlCam Basics

    #55754

    joe
    Participant

    Thanks for the comeback —  turns out I needed to change the com port on my laptop. — Joe

    #55755

    Ryan
    Keymaster

    You are not connecting to ESTLCAM directly correct right? That will flash it’s own firmware, you do not want that.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.