Ceramic greenware and bisqueware engraving

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Ceramic greenware and bisqueware engraving

This topic contains 1 reply, has 2 voices, and was last updated by  Chris 2 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #19607


    Machine size: 24×30 w/ 5″ z axis
    DW660 spindle (no speed control
    1/8″ 90 degree v bit (2 flute)
    Part number: 2002.1250.090 (from drillman1 on ebay)

    I will add a video next time I cut, but this stuff cuts like butter. I did some text in estlcam.
    Feed was 18 mm/sec,
    4.00mm plunge rate 4.00mm depth per pass (it probably went 1-2mm just whatever the carve function had dictated).

    The greenware made less dust, but the quality of the engraving was better on bisqueware.

    Also did the a mermaid with the same feed/speeds.
    The heart is greenware, the plate is bisqueware. I played with the depth on the greenware piece, so ignore the last two letters 🙂

    Pretty sure it could go much faster or deeper, but that feed was good enough for me.



    Very unique use of CNC! Is this all slipcast?

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.