can't get stepper Motors to move

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC can't get stepper Motors to move

This topic contains 2 replies, has 2 voices, and was last updated by  KFears 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #110047

    KFears
    Participant

    Hello all

    I purchased the mini Rambo Kit from this and have completed the build.

    I installed Estlcam to verify I had the wiring correct but I cannot get anything to move

    I attached a photo of my mini Rambo board

     

    Thanks

     

    Attachments:
    #110050

    Barry
    Participant

    Needs power.

    2 users thanked author for this post.
    #110117

    KFears
    Participant

    Thank for the response, I’m new to this. I have the power connected  so I will test the power to make sure that it is working

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.