Can't get Ramps to connect to lcd or repetier-host

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Can't get Ramps to connect to lcd or repetier-host

Tagged: , , ,

This topic contains 34 replies, has 6 voices, and was last updated by  Ryan 1 year, 11 months ago.

Viewing 5 posts - 31 through 35 (of 35 total)
  • Author
    Posts
  • #46702

    Teo Nordström
    Participant

    It’s likely not the cable as I’ve tried 3 different ones on two different computers. It’s most probably something with the arduino as it barely reacts to anything. I am probably going to buy that cheap one, 20 bucks isn’t too much, and I’d really like to see the machine moving. Thank you for trying to help me, everyone 🙂

    #46748

    Teo Nordström
    Participant

    The new card works! It was much easier spending 15$ to buy a new card, and it works. Thanks everyone for trying to help me! Now to figure out what to do with a broken arduino…

    #46844

    Teo Nordström
    Participant

    Another small question, now that Ive fixed it, i dont want it to break would I? There was no guide for this so i looked at photos to see, but this is how the external electricity should be wired, right? I’m no pro at these things. 

    #46845

    Barry
    Participant

    Should be good.

    #46846

    Ryan
    Keymaster

    Yup good to go.

    Ramps Stack

Viewing 5 posts - 31 through 35 (of 35 total)

You must be logged in to reply to this topic.