Canadian MPCNC

This topic contains 4 replies, has 3 voices, and was last updated by  Kyle 2 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #85926

    Kyle
    Participant

    Just have to finish the Z axis power and Vacuum Hose

    #85935

    Ryan
    Keymaster

    Short and Stout, love it!

    #86160

    dane
    Participant

    kyle did you use the burly c plans as i see ure using emt conduit did you find the 3/4″ conduit to be super tight in the feet?

    #86345

    Kyle
    Participant

    I didn’t have too much trouble getting the feet to fit.  My only real “issue” was the nuts  didn’t stay captive and had to use a flat head screwdriver on the nuts to hold them while tightening.  Other then that the design could not have been better! Super impressed by all the hard work that’s been put into this by the v1 team.  There support is amazing too. Kudos v1!

    1 user thanked author for this post.
    #97335

    Kyle
    Participant

    Just a quick update,

    I’ve added:

    • spindle speed control for the dw660 using a router speed controller
    • an endurance 3.5watt laser with a mount on the dw660, and dust covers
    • modified the x y endstops to have zip tie brackets to prevent me from accidentally knocking them off all the time.
    • Octoprint on a raspberry pi with all the custom commands I need for CNC
    • And old Android TV I am using to control octoprint in the shop

    I made some firmware modifications too:

    • Bed sizes input to prevent time out during homing
    • M73 enabled for octoprint
    • Aayrns Laser fix
    • Software end stops enabled for my bed size
    • This reply was modified 2 months ago by  Kyle.
    • This reply was modified 2 months ago by  Kyle.
    1 user thanked author for this post.
Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.