Built my MPCNC and now looking at the Low Rider

New Home Forum LowRider Advice – LowRider Built my MPCNC and now looking at the Low Rider

This topic contains 1 reply, has 2 voices, and was last updated by  Chas 3 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #33982

    Wayne A Hogue
    Participant

    Very impressed with the MPCNC, deadly accurate with the pen effector (only one I have atm, Dewalt and Titan Areo in route)

    I am looking for a sheet cutter for a wikihouse.cc build. It call for +- .5mm accuracy on the cuts. These are all through cuts.

    Question, will I be able to achieve this accuracy consistently? Will need to cut up to 100 sheets for the project.

    TIA

    -Wayne

    #105215

    Chas
    Participant

    @wayne A Hogue did you ever use the mpcnc or lowrider to cut wikihouse parts? I’m trying to do the same. Would like to know how it worked out for you.

     

    -Chas

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.