Broken corner brackets

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Broken corner brackets

This topic contains 5 replies, has 2 voices, and was last updated by  Jim 3 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #102289

    Jim
    Participant

    During a move the corner brackets and leg supports were broken. (The parts that connect the pipes at the corners) Can I purchase those pieces individually or must I purchase the entire kit of printed parts?

    #102319

    Ryan
    Keymaster

    Sure, post some pictures so we make sure we are talking about the same thing. I print all of them in sets so it will be priced as a set of four of each part you need.

    1 user thanked author for this post.
    Jim
    #102616

    Jim
    Participant
    Need all 4 corners.
    #102619

    Jim
    Participant

    I only need one of the bottom parts that clamps onto the leg.

    #102845

    Ryan
    Keymaster

    You want two bottom corners and two bottom cornerM’s, “j” size 25.4mm. Should I send the invoice to the email you used in this forum, and what country will they be being shipped to?

    1 user thanked author for this post.
    Jim
    #102978

    Jim
    Participant

    I need both pieces in photo. One of the leg clamps is also broken.

    Yes, send invoice to email on file. Ship to USA.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.