Bit Change/Reverse

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #32283


    So I have been trying to make some wall art items out of some old barn wood.

    I am using two different bits. 90 degree for engraving and then 1/4″ for cutting out the part.

    My question is this… when you guys do a tool change how do you make 100% sure that you are starting back off from the original homing position?

    On some of my engraving it seems like I need to rerun the job to clean it up but I cannot ever get it to home in exactly the same position and when I rerun its ever off so slightly but enough to mess up the engrave.

    Also, I have heard that if you run your job in reverse that it can clean up the job but I am not sure if that is true nor how you would even accomplish that in Estlcam.


Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.