Bigger buildplate on MP3DP

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP Bigger buildplate on MP3DP

This topic contains 7 replies, has 4 voices, and was last updated by  Bill 2 weeks, 3 days ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #103846

    Curt
    Participant

    I am toying around with tearing down my V2 and rebuilding with a 300 or 330mm build plate.  Has anyone else done this yet?

    #103867

    Ryan
    Keymaster

    Bill did, I am pretty sure, maybe even on both versions.

    #103880

    Jeffeb3
    Participant

    I’d be interested in doing that too. Maybe adding 50mm to the height too… Dunno. Mine is working great, but I haven’t changed anything in a while.

    #103939

    Curt
    Participant

    Bill who???

    #103940

    Curt
    Participant

    @billsey Hey Bill, are you the one Ryan is referring to that build a bigger mousetrap…I mean MP3DP?

     

    #104240

    Curt
    Participant

    @Ryan – Any chance dwg’ are available for the flat parts so I do not have to redraw from scratch?

    #104247

    Ryan
    Keymaster

    DXF’s are up.

    #105105

    Bill
    Participant

    Sorry, I’ve been gradually catching up after being away for six weeks. The XL uses a 300×380 build plate, since at the time that was the largest heater element I could find on aliexpress. Other than needing a bigger PSU (I used a 60A 12V) to drive the larger heater the build was pretty straight forward.

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.